Vutec LECTRIC I RF - Installation Instructions Instrukcja Użytkownika Pobierz pdf

LECTRIC I & III

BUILT-IN RF MOTOR

WALL OR UNDER CEILING MOUNT

The LECTRIC I or III screen may be mounted to the wall or ceiling as shown in Figures 1 and 2 below. The screen

comes with three mounting brackets and screws. Where possible, the mounting brackets should be installed to rigid

structural members. If this is not possible, suitable wall anchors or other mounting methods must be used.

GENERAL

Unless otherwise specified, the motor locates on the left end of the housing. The screen fabric rolls down from the

backside of the roller.

Figure 1

Wall Mounted Ceiling Mounted

Figure 2

Important considerations when deciding the mounting

location for the screen.

 The Housing Length (Figure 3) is as follow:

Housing Length = Viewing Width + 10 -¼" (Lectric I)

Housing Length = Viewing Width + 17 -½" (Lectric III)

 The screen is centered in the housing.

 The housing may be moved left or right after it has been

hang for final location.

Determine the housing length and Dim. K. A third mounting

bracket is recommended for middle support for screen of

96 inches viewing width or larger.

INSTALLATION

Dim. K should be approximately 1/6

to 1/8

of Housing

Length.

Install the mounting brackets as required. Be sure they are level

for proper contact with the housing.

Note: If the screen is wall mount, the mounting brackets must be

at least 1-½" inches from the ceiling as shown in Figure 1. If the

screen is ceiling mount, the mounting brackets must be at least

4- ¾" inches from the wall (Figure 2).

Figure 3

1 2

LECTRIC I & III BUILT-IN RF MOTOR WALL OR UNDER CEILING MOUNT The LECTRIC I or III screen may be mounted to the wall or ceiling as shown in

Back-off the locking screw for each mounting bracket so that it is even with the inside face of the bracket. Slightly tip the screen housing and fit

Brak uwag

Vutec LECTRIC I RF - Installation Instructions Instrukcja Użytkownika